Set QC General Parameters

Set QC General Parameters

1. Click the Open icon on the toolbar. The Select Form dialog box opens.
2. Type qc gen in the Filter field.
3. Click the QC General Parameters list item.
4. Click the OK button. The QC General Parameters form opens.
5. Verify the Prompt For Reason on Accept check box is selected. 
6. Verify the Prompt For Reason On Reject check box is selected. 
7. Verify the Check Failure Codes on Tests check box is selected.
8. Verify the Check Gauge Equipment on Tests check box is selected.
9. Verify the Check Methods on Tests check box is selected.
10. Verify the Required – if defined check box is selected in the Check For Test Results field.
11. Verify Employee is selected in the Inspector Validation field. Selecting Employee will ensure 
there is a valid employee number required when performing Receiver and MRR dispositioning.
12. Click the Map Inspector to Receiver drop-down arrow.
13. Click the None list item.
14. Click the Text tab.
Note: the CAR and MRR text.
15. Click the Email tab.
16. Verify No is selected in the Send Email when creating an MRR? field.
17. Verify No is selected in the Send Email when creating a CAR? field.
18. Click the Save icon.
19. Click the Close (X) button on the QC General Parameters form

    • Related Articles

    • Set QC general parameters

      1. Click the Open icon on the toolbar. The Select Form dialog box opens. 2. Type qc gen in the Filter field. 3. Click the QC General Parameters list item. 4. Click the OK button. The QC General Parameters form opens. 5. Verify the Prompt For Reason ...

    • Set QC General Paramters

      1. Click the Open icon on the toolbar. The Select Form dialog box opens. 2. Type qc gen in the Filter field. 3. Click the QC General Parameters list item. 4. Click the OK button. The QC General Parameters form opens. 5. Verify the Prompt For Reason ...

    • Update QC General Parameters email settings

      1. Click the Open icon on the toolbar. 2. Type qc general in the Filter field. 3. Click the QC General Parameters list item. 4. Click the OK button. The QC General Parameters form opens. 5. Click the Email tab. 6. Verify No is selected in the Send ...

    • Set QC Customers RMA parmeters

      1. Click the Open icon on the toolbar. 2. Type customer par in the Filter field. 3. Click the Customer Parameters list item. 4. Click the OK button. The Customer Parameters form opens. 5. Under the QC Customer RMA section verify the following check ...

    • Set up OPM parameters

      1. Click the Open icon. 2. Type shop floor in the Filter field. 3. Click the Shop Floor Control Parameters list item. 4. Click the OK button. The Shop Floor Control Parameters form opens. 5. Click the Outside Process Management tab. 6. Verify the ...